This lecture for CSEN102: Introduction to Computer Science, given by Milad Ghantous, PhD, covers fundamental programming constructs including conditional statements and loops.
Control structures are fundamental to programming as they dictate the flow of execution in a program. They allow programs to make decisions, repeat actions, and respond to various conditions.
Conditional statements allow a program to perform different actions based on whether a specified condition evaluates to true or false. They are essential for decision-making within programs.
Executes a block of code only if a condition is true.
if (condition) {
// code to execute if condition is true
}
Executes one block of code if the condition is true and another block if the condition is false.
if (condition) {
// code to execute if condition is true
} else {
// code to execute if condition is false
}
Allows for multiple conditions to be checked in sequence.
if (condition1) {
// code for condition1
} else if (condition2) {
// code for condition2
} else {
// code if none of the above conditions are met
}
Provides a way to select one of many code blocks to be executed. Often used when comparing a single variable against multiple discrete values.
switch (variable) {
case value1:
// code if variable matches value1
break;
case value2:
// code if variable matches value2
break;
default:
// code if variable does not match any case
}
Used to combine or modify conditions:
AND (&&): Both conditions must be true.OR (||): At least one condition must be true.NOT (!): Reverses the logical state of the condition.Loops allow a block of code to be executed repeatedly until a certain condition is met or a specified number of times.
Repeats a block of code as long as a condition is true. The condition is checked before each iteration.
while (condition) {
// code to repeat
}
Similar to a while loop, but the code block is executed at least once before the condition is checked. The condition is checked after each iteration.
do {
// code to repeat
} while (condition);
Repeats a block of code a specific number of times. It is typically used when the number of iterations is known beforehand.
for (initialization; condition; increment/decrement) {
// code to repeat
}
break;: Terminates the loop immediately.continue;: Skips the rest of the current iteration and proceeds to the next iteration of the loop.Thank you